Audiovox DVD-220 Guide d'installation Page 27

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 47
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 26
TROUBLESHOOTING
PROBLEM
IR remote inoperative
Disc won't play
Play starts, but then stops immediately
No sound or distorted sound
Can't advance through a movie
SOLUTION
Verify that the batteries
in
the remote are fresh.
Verify that the remote sensor eye is not obstructed.
Insert a disc with the label side facing up.
Check the type of disc you put into disc tray. This DVD only plays DVDs, audio CDs
and MP3s.
Both the unit and the disc are coded by region. If the regional codes don't match, the
disc can't be played.
The disc
is
dirty. Clean
it.
Condensation has formed. Allow player to dry out.
Make sure your DVD is connected properly. Make sure all cables are securely
inserted into the appropriate jacks.
If you are using the
2-channellR
headphones, make sure you turn
on
the
IR
headphone power, make sure the correct channel (A-B) is selected.
Make sure the Modulator is
ON
and the proper Frequency has been selected.
Make sure that unit
is
set to
M1
when using Single Channel Headphones.
It
can't advance through the opening credits and warning information that appear
at the beginning of movies because the disc is programmed to prohibit that action.
27
Vue de la page 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 46 47

Commentaires sur ces manuels

Pas de commentaire