Audiovox PRO9056 Manuel d'installation télécharger pdf (Page 18)

128-8857b

18 of 24

COMPLETING THE INSTALLATION

1. Mount the control module up and behind the dash securing it in place with cable ties or screws. Be

certain that the chosen mounting location will not inhibit any of the controls of the vehicle.

2. Securely harness and tie all wiring up and away from all hot and moving parts that they may come in

contact with under the dash board or in the engine compartment areas.

CAUTION: Particularly avoid the area around the steering shaft and column, as wires can wrap around

these mechanisms and impair the safe operation of the vehicle.

3. Apply the Caution Labels supplied with this kit to a conspicuous area in the engine compartment. Make

sure to clean the surface before affixing the label.

4. Check the vehicle's wipers, lights, horn, etc.... to insure proper operation.

5. Replace all panels that were removed during installation, and retest the system.

6. Explain all activated features and safety systems associated with the Remote Start Unit installed. Also

point out the location of the Push-Button LED Override/Valet switch to the customer and explain its

operation.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Audiovox PRO9056 Manuel d'installation Page 18