Audiovox APS-510 Manuel d'installation télécharger pdf (Page 1)

128-8538

1 of 8

Page 1

Model APS-510N

Installation Manual

Note: The method of manual override can either be selected to operate from the valet switch or operate as custom

code. Be certain to place a check mark indicating the method used in the box located on the last page of the

owner's manual.

Note: When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin

switch in order to begin the passive arming sequence.

RF Programmable Features :

Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps 5 Chirps Default

1st Door L/UL 1 Sec. 3.5 Sec. 1 S L, Dbl.U/L 350mS UL/1SL 1 Sec.

2nd Accy Lock Auto Lock On Auto Lock Off Auto Lock Off

3rd Accy. UL Auto UL Dr Auto UL All Auto UL Off Auto UL Off

4th Headlights On Arm On Disarm On Both Off Both

5th Passive Locks Passive Active Active

6th Passive/Active Arm Passive Arm Active Arm Active Arm

7th Voltage Sense Voltage Sense Hardwire Hardwire

8th Siren/Horn Siren/Horn Siren Only Horn Only Siren/Horn

9th Horn Chirp 10mS 16mS 30mS 40mS 50mS 16mS

10th Override Method Custom Code Valet Valet

11th Two Step Unlock On Off Off

12th Chirp Delete From Tx On Off O f f

To program these selectable features;

Action System Response

Turn ignition on No response

Press and release the valet switch 3 times 1 Chirp - LED 1 flash

Within 3 seconds, turn ignition Off Short chirp, then long chirp

First Then On 1 chirp = 1 second door locks

Press transmitter Lock button to change 2 chirps = 3.5 second door locks

Press transmitter Lock button to change 3 chirps = 1 sec. lock, dbl 1 sec. unlock

Press transmitter Lock button to change 4 chirps = 350mS unlock 1 second lock

Second Press and release the valet switch 2 chirps = auto locks off

Press transmitter Lock button to change 1 chirp = auto locks on

Third Press and release the valet switch 3 chirps = auto unlock off

Press transmitter Lock button to change 1 chirp = auto unlock drivers door only

Press transmitter Lock button to change 2 chirps = auto unlock all doors

Fourth Press and release the valet switch 3 chirps = headlight output when arming and disarming

Press transmitter Lock button to change 4 chirps = headlight output off

Press transmitter Lock button to change 1 chirp = headlight output when arming

Press transmitter Lock button to change 2 chirps = headlight output when disarming

1 2 3 4 5 6 7 8

Model APS-510N 1
128-8538 2

Résumé du contenu

Page 1 - Model APS-510N

128-85381 of 8Page 1Model APS-510NInstallation ManualNote: The method of manual override can either be selected to operate from the valet switch or op

Page 2 - 128-8538

128-85382 of 8Page 2Fifth Press and release the valet switch 2 chirps = active locksPress transmitter Lock button to change 1 chirp = passive locksorS

Page 3

128-85383 of 8Page 3Control Module:Select a mounting location inside the passenger compartment ( up behind the dash ), and secure using thetwo screws

Page 4

128-85384 of 8Page 4alarm or to unlock the doors and provides a continuous pulsed output whenever the alarm is triggered. Thiswire should be connecte

Page 5

128-85385 of 8Page 5Dark Green Wire: ( - ) INSTANT TRIGGER ZONEThis is an instant on ground trigger wire. It must be connected to the optional previou

Page 6

128-85386 of 8Page 63 Wire Ground Switched Single Step Door LocksIn this application, the red wire provides a ground pulse during arming, or the pulse

Page 7

128-85387 of 8Page 7Resistive Circuits, As Well As 4 Wire Polarity Reversal and 5 Wire Alternating 12 VoltDoor Lock Control CircuitsThese applications

Page 8