Audiovox IMO-720 Manuel d'utilisateur télécharger pdf

Model IMO-720

Installation Manual

IMO-720 Two Circuit Immobilizer System

Kit Contents:

Control Module

5 Pin Main Control Module Wiring Harness

4 Pin High Current Inhibit Circuit Wiring Harness

Valet/Override Switch/LED Combination Assembly

2 Pin Exciter Coil

Consumer Transponder/Information Kit

Operation:

The IMO-720 Immobilizer is a passive arming security system. When the ignition switch is turned off, the LED

begins to flash rapidly, indicating that the circuit will arm in 15 seconds.

After the 15 second arming period, the LED will begin it’s slow flash pattern, indicating that the circuit is armed.

NOTE: The arming cycle can be suspended anytime during the initial 15 seconds by turning the ignition switch

to the on position.

Once the circuit has armed, the vehicle will not start unless a programmed transponder is used or, the manual

override sequence is operated.

When the vehicle door is opened, or when the ignition switch is turned to the on position, the exciter coil is

energized and capable of reading a programmed transponder.

When a transponder is placed within the exciter coil’s field, (Appx. 6”), the unit disarms. This is indicated by the

LED turning off.

Because the programmed transponder is attached the vehicle’s key ring, the operation of this unit is transparent

to the user. Arming and Disarming takes place automatically.

Control Module Mounting:

Select an inconspicuous mounting location below the driver’s side dashboard that is within 30 inches of the

ignition key cylinder. Be certain your chosen location is away from the vehicle’s steering shaft, (column), to

prevent interference with the proper operation and control of the vehicle. Secure the module to a existing brace or,

wiring harness using cable ties.

Mounting The Valet/Override Switch/LED Assembly:

Select a mounting location within the drivers area that is accessible to the operator of the vehicle and

clearly visible from the outside of the vehicle’s front left and right windows. This switch does not have to be

hidden as the system cannot be disarmed unless the pre-programmed transponder is used or the custom

override code sequence is operated.

Mounting The Exciter Coil:

The loop exciter/antenna coil is designed to be placed around the vehicle’s ignition key cylinder. In certain

vehicles it will be necessary to remove the shroud surrounding the steering column, in other vehicles it may be

necessary to remove the cylinder from the dash panel. The information below references both these applications.

Vehicles with steering column ignition cylinders:

Remove the upper and lower half of the steering column shroud to gain access to the ignition key cylinder. Place

the loop coil around the ignition cylinder. Route the twisted pair of Black and Black w/White stripe wires toward

the control module.

Replace the upper and lower halves of the steering column shroud using care not to pinch the wire’s of the routed

exciter coil harness.

1 2 3 4 5

Résumé du contenu

Page 1 - Model IMO-720

Model IMO-720Installation ManualIMO-720 Two Circuit Immobilizer SystemKit Contents:Control Module5 Pin Main Control Module Wiring Harness4 Pin High Cu

Page 2 - Wiring The Control Module:

Vehicles with dash mounted ignition switches:Remove the lower dash panel to gain access to the ignition key cylinder. Carefully remove the ignition ke

Page 3

34 Pin Inhibit Control Harness:6 Inhibit Circuit Relay #1 Open Contact7 Inhibit Circuit Relay #1 Common Contact8 Inhibit Circuit Relay #2 Common Conta

Page 4

4NOTE:If the consumer transponder is programmed, the dealer transponder will be erased and renderedinoperative. When the dealer transponder are progra

Page 5 - 128-5342A

5128-5342ADevice Side Of The Circuit YouDevice Side Of The Circuit You