Audiovox ADC700 Manuel du propriétaire Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 73
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
® PRESET <I >f1!lmI
Selects a preset FM/AM station when TUNER is selected
as the input source (see page 24).
Selects a preset SIRIUS channel when SIRIUS
is
selected
as the input source (see page 31).
@)
FM/CATEGORY
<:J,
AM/CATEGORY
l>
f1!lmI
Sets the FM/AM tuner band
to
FM or AM when TUNER
is
selected
as
the input source (see page 20).
Selects a channel category when SIRIUS
is
selected as the
input source (see page 29).
® TUNING/CH <<I >>
fI!lmII
Selects the tuning frequency when TUNER
is
selected as
the input source (see page 20).
Searches for a SIRIUS channel when SIRIUS
is
selected
as the input source (see page 29).
® Remote control sensor
Receives infrared signals from the remote control.
Note
Switch the remote control ID between IDI and
1D2
when using
multiple Yamaha receivers or amplifiers (see page 44).
@
ZONE2
Turns on Zone 2 or sets ZONE 2 to standby mode. When
Zone 2 is turned on, signals are output
to
the ZONE 2
OUT jacks (see page 45).
@ ZONE 2 CONTROL
Allows buttons and controls on the front panel to be used
to
control Zone
2.
For more information about controlling
Zone 2, see page 46.
@ CD DIRECT AMP and indicator (R-S700 only)
Allows you
to
listen to a CD source
in
the purest possible
sound (see page 17). The indicator lights
up
and the front
panel display turns
off
when this function
is
turned on.
Notes
Ifboth
the CD DIRECT AMP and the PURE DIRECT are
turned on, only the
CD
DIRECT AMP will function.
Zone 2 cannot be used while this function
is
turned on.
@ PURE DIRECT and indicator
Allows you to listen
to
a source
in
the purest possible
sound (see page 17). The indicator above it lights up and
the front panel display turns
off
when this function is
turned on.
Note
Zone 2 cannot be used while this function
is
turned on.
@ PHONES jack
Outputs audio
to
your headphones for private listening.
Note
Press SPEAKER
AlB
so that the SP
AlB
indicators
tum
off
before you connect your headphones to the PHONES jack.
CONTROLS
AND
FUNCTIONS
@ REC OUT selector
Selects a source for recording
to
a CD recorder or to a tape
deck independently
of
the INPUT selector setting,
allowing you to record the selected source while listening
to another source (see page 19).
@ BASS control
Increases or decreases the low frequency response. The
center position produces a flat response (see page 18).
® TREBLE control
Increases or decreases the high frequency response. The
center position produces a flat response (see page 18).
@ BALANCE control
Adjusts the sound output balance
of
the left and right
speakers to compensate for sound imbalances caused by
speaker locations or listening room conditions (see page
18).
@ LOUDNESS control
Retains a full tonal range at any volume level to
compensate for the human ears' loss
of
sensitivity to high
and low-frequency ranges at a low volume level (see page
18).
® INPUT selector
f1!lmI
Selects the input source you want to listen to.
® VOLUME control
(f1!lmI
R·S700 only)
Increases or decreases the sound output level.
Nott,-
This does not affect the output level
of
the REC jacks.
5 En
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 72 73

Commentaires sur ces manuels

Pas de commentaire