Audiovox APS-25CH Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Alarme de voiture Audiovox APS-25CH. Audiovox APS-25CH User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
128-6453
1 of 8
Model APS-25CH
Installation Manual
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch
in order to begin the passive arming sequence.
RF Programmable Features :
Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps Default
1st Door L/UL 1 Sec. 3.5 Sec. 1 Sec L, Dbl. U/L 1 Sec.
2nd Accy Lock Auto Lock On Auto Lock Off Auto Lock Off
3rd Accy. UL Auto UL On Auto UL Off Auto UL Off
4th Passive Locks Passive Active Active
5th Passive/Active Arm Passive Arm Active Arm Active Arm
6th Voltage Sense Voltage Sense Hardwire Hardwire
To program these selectable features;
Action System Response
Turn ignition on No response
Press and release the valet switch 3 times 1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off Short chirp, then long chirp
First Then On 1 chirp = 1 second door locks
Press transmitter Lock button to change 2 chirps = 3.5 second door locks
Press transmitter Lock button to change 3 chirps = 1 sec. lock, dbl 1 sec. unlock
or
Second Press and release the valet switch 2 chirps = auto locks off
Press transmitter Lock button to change 1 chirp = auto locks on
or
Third Press and release the valet switch 2 chirps = auto unlock off
Press transmitter Lock button to change 1 chirp = auto unlock on.
or
Fourth Press and release the valet switch 2 chirps = active locks
Press transmitter Lock button to change 1 chirp = passive locks
or
Fifth Press and release the valet switch 2 chirps = active arming
Press transmitter Lock button to change 1 chirp = passive arming
or
Sixth Press and release the valet switch 2 chirps = hardwire
Press transmitter Lock button to change 1 chirp = voltage sense
or
Turn ignition key off Exit program mode
Note: Once you enter the feature programming mode, do not allow more than 30 seconds to pass between steps, or the
programming will be terminated.
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Model APS-25CH

128-64531 of 8Model APS-25CHInstallation ManualNote : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door

Page 2 - 128-6453

128-64532 of 8Page 2CHANNEL 2 OUTPUT:This system provides an additional hardwire remote output to control an assortment of optional upgrades.This outp

Page 3

128-64533 of 8Page 3VALET SWITCH:Select a desired mounting location for the switch, that is easily accessible to the driver of the vehicle.The switch

Page 4

128-64534 of 8DARK GREEN WIRE: (-) INSTANT TRIGGERThis is an instant on ground trigger wire. It must be connected to the previously installed hood and

Page 5

128-64535 of 83 Wire Positive Switched Door LocksIn this application, the red wire provides a positive pulse during disarming (pulsed + 12 volt unlock

Page 6

128-64536 of 8THIS PAGE LEFT BLANK INTENTIONALLY

Page 7

128-64537 of 8

Page 8

128-64538 of 8© 2003 Audiovox Electronic Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-6453

Commentaires sur ces manuels

Pas de commentaire